Recent content by reelredfish

OK I plan to head over in the next cpl weeks. Can get picks and details when I do. Wanted to see if yall had ideas I could check.

Helping a relative with his setup. Somehow all of his programming was deleted. I corrected all of that and have everything working again from the APP. They have an attached spa to the pool and the one item I could not get to work is the Jandy heater. For some reason I am not able to adjust the...

But its not used for backwashing correct? Just the one time a year where the rain wont stop and we need to let water out of the pool before it runs over. Only way to clean is remove them and spray them off?

In the summer a gallon per week. I am looking at the same ranges on PH which you have. I dont think the new plaster would still be causing an increase at this point right?

I have them set to exactly what you mention just to keep lines clean and with fresh water. However in the summer its a battle cause we run them a lot plus the spa is used a lot. SO we get a lot of PH increase from this not to mention the SWG. No need in paying for water features if you cant use...

So I have read several DIY setups for probes to monitor PH and eve dose acid. However most of those were several years old. I am wondering now that time has past if there is a packaged unit for doing this and what folks recommend or have feedback on. I fight PH on our pool here and it is one...

Tagging along as for I have the same DE filter and thinking about a change this year. When pool was built it had a cartridge with 4 large ones. We changed to DE many years ago as for we had a large oak tree in backyard and it seemed like it gave the filters heck. Also 22 years ago or so they...

That makes since thanks for the input! After I increased the SPA RPMs to 3400 it made a huge impact. Back to something I can live with now plan to put a control in place for SPA blower as for I changed it out to a lower HP which helped but it still blows water out. Hope to be able to dial it...

I just cleaned the filters this past weekend Yes it seems as if I do not get the flow that I used to have. We had 4 jets which was kinda crazy one whole portion had no jets so we added two more for a total of 6. The pump runs like its in startup mode and never ramps up. I will try setting it to...

Thanks I checked that and do see where they are off by 100 RPMS. However its much slower than that I moved it up to 3000 RPM's and its still slow. My old smaller non variable speed pump put out more pressure in the spa than this one. However We had them add two more jets during remodel. But this...

Since our pool was built with the pool and Spa sharing one pump using the I aqualink to change from pool to spa mode. I have since replaced pump to a new E Pump and notice that when in Spa mode it runs at a lower RPM. While I know how to change RPM's for the pump and freeze mode I am not sure...

Moved from HERE I know older post but I have 8 glowbrites in pool and one microbrite in spa. I cant get over how the spa does not match the pool with most of the colors. I have one extra glowbrite and trying to figure out how I could install it into the 1.5" threaded adapter in spa so that all...

So I purchased this and used it for about a month with zero issues. Then placed it in the garage while we have been going through a long pool remodel. Never had a single issue with it before. Now I have it back in the pool and each time I want to use it I have to delete it from the Iaqua link...

Any pics of your setup?

Correct that is the only way I have found to do it not a very useful solution IMO. Guess I am going to have to play around with it more. Would have been nice to give you more control directly from the app to ramp up or down speed without having to go into system setup and change the speed which...