Recent content by r1100ron

I ordered the Uniboost to replace my noisy PB4-60. It took a little re-plumbing since mine is plumbed with rigid pvc. But it's quiet and the cleaner actually works better than before. I'm sure the old motor wasn't running at top speed since the bearings were failing. But the Uniboost has a 1.5...

That's what I thought too. Thanks for the advice. Sent from my SM-N900T using Tapatalk

I mentioned in my posted that a mama rat used the insulation blanket under the boiler assembly to build a nest. Should I worry about replacing it?

Yep! Sent from my SM-N900T using Tapatalk

Update. I installed a VS pump last year while the valve was broken. Apparently the working valve now restricts flow, so I am having to adjust my pump rpm settings up to compensate.

Assuming yours has been fixed in the last 3 years.......I just replaced mine (posting for the benefit of others). My heater would fire, start making a popping noise, then shut down. At first it was intermittent...but then it became constant and the heater was non-functional. I tore it apart...

Update: sent sensor back to Jandy with instructions to insert it in a bodily orifice that may not be too comfortable. At least I got it off my chest.

Update: random "no flow" errors. Installed adapter board and no problems since. Also packaged up bad sensor and shipped to Jandy with a note instructing them to insert it where many folks would not insert such things. You pay a premium price, you expect a quality product.

Tri-sensor was bad. The new one works just fine without the adapter board.

The problem turned out to be a bad tri-sensor. Unfortunately, Jandy doesn't provide warranty on self-installations. So I probably just spent the money I saved installing it myself. Lesson learned.

Both main board and tri flow interface boards are green. Which one?

Yep. Tried all configurations.

Which board are you referring to? The adapter board or the main control board inside the AquaPure? I just completed a self-install and cannot get rid of the "No Flow" error. I've tried holding the reset button on the adapter board (flow indicator LED (green) flashes constantly). Called Jandy...

I installed it and now I get 145. Too much salt. Apparently my pool is not 18k gallons as my builder told me. Currently pumping out about 1/3 of the water. :-(