Recent content by pinch52

Thank you, I will try this 🙏🙏

Hi all, Recently I’ve noticed that when the automation center(pentair easytouch 8) calls for the valves(compool cv 24) to go from pool mode to spa mode, only one of the two valves moves to the proper position. I checked the switch on the outside of the valve case, it’s in the normal switch...

Thanks TS, good advice. I tried replacing all rubber in the valve. Will now try replacing the valve cover. Read that may have cracked due to the excess heat from dry running

Hi all, I recently rebuilt my whisperflo pump when the water evaporated below the skimmer and the pump ran dry. Must have gotten very hot in there. The pot housing, cap, lid, shaft seal, seal plate and unions have been replaced. All plumbing connections appear be solid. No water leaks...

Perfect, thanks for all the info. I found this guide, if anyone is interested

If I were to get a new one, does it come factory adjusted or is there a process for getting the new one set up?

Hi all, Tried to fire up the heater and got an ERR PS message on the lcd screen. Backwashed the filter and that solved the problem, heater fired up. However, it got me thinking about the heater pressure switch. It’s roughly 13 years old and I’m trying to determine whether it’s still...

Thank Rich, for the reply. As it turned out, my old board had gone bad and the new, oem board solved the issue. Of course, that’s all with the help of the fine tech contributors at TFP!! :cheers:

Great info, I will look in to it.

It was installed 2010. No flooding but it is salt water. There seems to be a small bit of water seeping out onto the ground around the manifold too. I’m surprised they are so bad. I don’t think I can even put a socket on some the bolt heads. Will have to grind those down use an easy out...

Bingo!! Makes sense. Thanks AJ for all the help !!! U, me and my son have the exact same initials. AJW😁. Have a great weekend brother. Next project will be to replace the 12 bolts that attach the manifold to the heater. They are totally rusted out. I will replace the thermal reg and bypass...