Recent content by outgolfingc

Hello, hope someone on here might be able to point me in the right direction. Noticed my heater keeps cycling on and off, throwing a check heater error message. It starts heating fine, then turns of with light indicating service heater, then turns back on and heats again. It stays heating long...

Thanks for the info. Just had a chance to try out some of the suggestions. The stack temp is what is displaying. If I hit the on button, it will change to water temp. But after a bit always goes back to stack temp. Initial startup shows water temp, once heating kicks on it goes to stack temp...

Thank you, will try this.

sure, does this help?

I did, not till last summer though. Almost gave up but Facebook Market place found its new home.

Hello, Have the above heater which controlled by Screen Logic. Noticed on the last few spa heatings, the heater just shuts off before reaching set temp. Noticed it kicks off around 85F. It never kicks back on. I have to toggle the spa on and off using the Screenlogic app, then it fires back up...

Robots are great, but can tell you that Polaris has a real issue with quality on their robots. My 9550 Sport model needs repair in under 4 years. From what I hear, not uncommon. I took great care of it too. Repairs are expensive, almost price of a new robot. It is a real shame as it was a very...

Wanted to see if anyone had advice on whether to repair or just replace my Polaris 9550 Sport. It is almost 5-years old, and looks to have a bad cord. From what I see, you can replace yourself for about $200-300. The pool store place I use said it will cost almost $400 from him to replace. The...

Thanks for the response. Exactly what I needed. Now starts thew next phase of pool ownership, replacement and repair.

Hello, Looking for some help on Globrite light. Noticed that the light in my Spa started acting funny. Didn't go out completely, just cycled to a low dim blue. Tried resynching, changing schemes, turning off and on. Each time it would come back on like normal, then cycle back to the low dim blue...

Moved from here.. No matter what I do the pH keeps climbing. I hope you don't mind me piggybacking off this post, but I have a question reagrding this topic. I have had the same chronic pH issue with new plaster pool. I do have a few water features and a spa spillover. But in my fourth season...

Good to know, thanks. Any other product/brand you would recommend that will work with Pentair automation system?

Hello All, Do you know if you can use the Pentair IntelliChem controller for just monitoring your pool levels, but not hooked up to external pumps for adding chems? I am ok with adding chems myself, just looking for a lazy way to know my levels. Not quite sold yet on adding the Acid and Chlorine...