Recent content by nwsurfer

Great. Thank you both!

I have a SWG and plaster pool with tile at the water line so, based on what I have read, it is important for me to keep the CSI within the -.3 to .3 range. Unfortunately, my CSI has been lower than -.3 for a couple of weeks now. Most recent test results: FC 8.5 pH 7.4 TA 70 CH 425 CYA 70 SALT...

Thank you both for your help! I really appreciate it. While I know this isn't the correct way to set it up, I can confirm if you set the Pool circuit egg-timer to "Do not stop", it does keep the pump running 24/7. Thanks again. Sincerely, Todd

I appologize for the confusion. I believe it is completely my fault. Basically I was asking if there is any way to change the default circuit timeout of 12 hours on the EzeTouch until the pump can communicate with the EasyTouch. The power for the pump is tied into the "Filter/Pump" button on the...

Thank you for the help. I have a feeling that the pool installers did whatever was easiest to do. While I wait for the installers to come out and install the RS-485 cable, is there a way to turn off the default circuit timer?

Thank you for the quick response. I really appreciate it. To clarify, I have an IntelliPro 3 pump, not a IntelliFlo 3 pump. Although, I doubt it makes much of a difference in this situation. As far as I can tell, the pool installers didn't hook up a RS-485 cable. I have been running the pump...

Hi Jim, Thank you for your quick reply. I have tried to set a schedule for (a) 8 am to 8 am and (b) set two schedule which comprises of 24 hours (8 am to 5 pm and 5 pm to 8 am) but unfortunately neither of them keep the pump running 24/7. It is almost like the Easy Touch has a egg timer (even...

I know this is a old post but I'm having the same issue with my newly installed EasyTouch. @feuGene Did you figure out what was causing the problem?

@Texas Splash Thank you for the help! I'll continue to try to figure out how to replace the filter. I had a pool construction company come out and give me an estimate but he wanted to just replace the whole pad for some $$. I'll try a couple of more companies. I think the problem I am going to...

Absolutely but I have to warn you, the set up might make you cringe. It is serious a mess of pipes going everywhere. At the bottom, the four intake values are, starting from the left, hot tub, far skimmer, main drain, and near skimmer. The far skimmer is completely shut. I'm not sure why. The...