Just installed a Agualink RS one touch. All appears ok but temperature sensor information on control panel show "sensor short" when in spa mode but the pool mode shows correct temperature--- any idea what is going on and what solution is?
thanks
Seeking further clarification
The first question relates to the electrical efficiency of an uprated motor (used by WFDS26) vs a full rated motor (used by
WFDS4)
The CEC data suggests that a pump with the same impeller but different motors has significantly different efficiency
or said another...
great- thanks for the suggestion on relocating the VR
One other thing I noticed in the CEC data regarding the Whisperflo 2 speed pumps-
These pumps come in two flavors based on max or uprated motors
Since the high speed if for Spa jets or priming, i have assumed that an efficient 1 HP pump...
I did confirm with Jandy that the Aqualink can be set to run low speed with solar (i havent demonstrated this yet)
Sequence might be== Initial filter pump start is on high speed to prime the lines followed by low speed during the balance of the filtration cycle
When solar is turned on during...
thanks for your thoughts
New pump vs new motor
Current pump is 5 years old and runs fine
However, a new pump is ~$550 vs switch to a 2 spd motor is ~$350; so am thinking a new pump would be better choice- your thoughts?
REgarding priming the panels on low speed
I have a Aqualink RS6 One touch...
I need assistance with a system question…
I have a combination pool (25k) and spa (4 jets) with ground mounted solar panels (7 FAFCO panels (4' x 8') -top of solar panels are 10' above pool level)
System currently uses :
1 HP Northstar pump (SF is 1.85) with...