Recent content by mst442

First...THANK YOU so much for your help! You have no idea how much it is appreciated! How don't think I have the Sense and Dispense System and am turning that off as I think I may have turned that on, which obviously created this problem. I believe I'm all set. Appreciate this...

Installed new salt cell and reading salt level perfectly. However getting "check system csm comm error". I remember unlocking config and did look at something like chem wizard. I may have accidentally changed a setting. Is there standard setting that I should have? (By the way I made...

Turned off breaker for 10 minutes and that didn’t fix it. Remote display and Pro Logic unit still shows Salt Level 0000 PPM in Diagnostic update test mode.. But T5 Calibration Locked now shows on Menu, along with Settings,Timers,Diagnostic,configuration Menu-Locked. I don’t recall seeing T5...

Will turn off the breaker as you suggest. Also getting “T5 Calibration Locked” message on remote display. I don’t recall seeing this before…?

I have not power cycled the pro Logic panel. Not sure how to do that. +30.71v. +0.08A. 83° 0000PPM What exactly do you mean when saying “power cycled”?

Have a Pro Logic system: accidentally added too much salt. Drained some water out and is at good level now after having water tested at pool store. Problem is Pro Logic still shows 0000 and blinking “check system.” Have gone to menu into Diagnostic to get new salt level reading but also...