Recent content by Mr T

Did as you advised connecting only the Chlorinator to the J20. Although the lights were on the chlorinator showing 20% it did not change amount when i used the easytouch LCD to adjust the amount. Also status on LCD showed active for chlorinator.

Makes sense, I disconnected everything from J20 except two wires from RS-485 cable. Turned on power to Easytouch and pump. Checked pump and no display not active on pump. RS-485 cable is new. Status for pump still shows no com.

intel inflow VPS pump is about 3 years old. I can turn on blower and pool lights from Easytouch. My remote antenna has no power no tranceiver. When I turn on pump from Easytouch I hear a click sound. As I said intellichlor works and shows comm but not pump. Have reset both and nothing.

Inteliflow does not show display not active, its shows pump speed. Status on Easytouch shows No Comm. I replaced the RS-485 cable but nothing changed. Programs are all set to manual. Intechlor working fine. I reset pump & eashtouch with no luck.

Moved from here. I have same issue. Tranceiver model is 520949 but there are no lights lit on the transmitter ! Checked all connections and they are good.

Yes, this is the only device.

OK thanks, I'll try your suggestions, also I took the transmitter to the easytouch control box & plugged it in to the com port. It did the same thing it did when I unplugged it at the other end. (where the transmitter was mounted).

When I unplug the terminal block as you instructed & plug it back in the LED on the top left (the one that is suppose to blink 3 times to reset does nothing) however these is another LED just below it. When I plugged the terminal back in that one blinks 5 times then stops. tried to reset the...

Yes that is the one I have. When I push the reset button nothing happpens. I disconnected the terminal wires and plugged it back into the transceiver. The light below the reset light blinked 3 times and went off. Pushing the reset button does nothing.

Yes all inlets open, not restricted. Checked blower and nothing in veins. Heater is about 2 years old, all new electrical parts.

Lost connection to my 4 button wireless remote. Tried to push the reset button on transmitter but nothing happens, no 3 blinking lights to reset remote. Wires seem to be conected ok on bot ends???

Its the hard "Plastic Case" that covers the heater parts from the elements, takes 4 screws to remove.

I have a Sta-Rite SR333NA pool heater. Everything works fine with the pool heater cover off but with the cover on the heater keeps cycling on & off. There are no error codes or service heater lights on the display. I have put in all new electrical components but still no solution. It feels like...

OK all my lights are GREEN on my Intellichlor IC40 and the salt output level is set at 40% with 2 Green lights on but on my Easytouch when I check diagnostics to get my salt level it shows 0 ppm. The status light shows OK-No errors!!!!!!! Where is the issue?

Checked connection & ET is set to on.