Recent content by Mkubacki

you have to make sure you have 220v between the two because a 220v motor can send 120v back through it giving you false readings check with one lead on each hot wire there could be a chance breaker went bad trust me I have had this happen to me!

Make sure it's sunny out use a vacuum through the skimmer opening it will suck all the air out and help stretch the liner at that point adjust liner to get small wrinkles out! I did my 27' unibead liner by myself on a 75° sunny day and it melted in there like butter

I just started noticing small spots and lines of algae on the bottom of my pool I will admit that my FC did drop to 1.0 when we got a alot ton of rain and water turned kinda cloudy so I turned up the SWG and adds Some liquid chlorine it's been about four days now and two brushings they are still...

Feherguard makes a 30' solar reel!

90$ each for your double pole breakers 50$ for single 15 amp gfci breaker and 12$ for double pole switch so about 250$ in parts minus the timer they are over pricing everything big time can't hurt to call someone else for a second opinion

I have to stick my finger in the bottom sometimes to get the impeller spinning again inside then it works fine if that's not spinning it will not crawl around

Cut the gfci end off and put regular cord end on it since you are plugging it into a gfci!

That hand either an end that went onto a female spade or went under a screw look where the other end is then crimp a new end back on might have to loosen a screw or two to find it hope that helps

There should be a bracket attached to the pilot assembly with screws so you can remove all the pilot tubing and assembly then you should check for any loose fittings on and around the end. Also wire brush it to clean it up there is also an orfice inside the pilot assembly make sure that is...

I have insignias on my patio under the eve of the house for three years now and sound great I never take them in in the winter I paid 100$ for the pair from Best Buy!

It requires 250 pounds of sand that's all I can tell ya right now

I I found a good deal on a Hayward s244s sand filter is to big for what I have and also can it be used for aboveground pool as they say it's for an inground?

There's not a lot of difference between the 1hp and the 1.5hp GPM am I still ok for the S166T filter with only 1.40 ft filter area or is it a lot bigger difference than I think? Am I ok or do I need to get bigger filter?