Recent content by mbeavers1

  1. M

    Converting Intellichem into Pump only

    OCLT showed 0.3ish when I check a few weeks back so with CC of 0, i should be good.
  2. M

    Converting Intellichem into Pump only

    I guess i wasnt really clear. I was more curious if I should try to keep my min higher than 2.5 if Im losing ~3 per day....around say 3.5-4 to keep me from going to 0.
  3. M

    Converting Intellichem into Pump only

    Hi all, I used my intellichem system for the last 2 years mostly successfully but this year I used dramatically more Cl so have messed with things a bunch. My plan is to use it to sense and adjust pH because it does well there but only use the CL side to pump a preset CL volume by controlling...
  4. M

    Salty Tasting Cl Pool Water

    This summer I have noticed that my water has a fairly salty taste. It stays pretty balanced but has taken more Cl to stay that way this year. I did do an OCLT last night and am borderline (lost 0.4-0.5ppm) but no CC. Water clear, nada growing on walls. Here are my latest numbers: pH: 7.6 FC...
  5. M

    Pentair Mastertemp 400 Screen problem

    In luck! Since it was a new build and all my equipment is Pentair, I did qualify for the 3yr warranty. They confirmed the board does have to be replaced and sending someone this week. Thanks for the help @ajw22!
  6. M

    Pentair Mastertemp 400 Screen problem

    2.5yrs....so just out of warranty likely
  7. M

    Pentair Mastertemp 400 Screen problem

    It also seems that this relay is on the board, meaning a complete replacement. 😒. Guess ill be callimg Pentair tomorrow. Thanks for the help!
  8. 20210718_112348.jpg

    20210718_112348.jpg

  9. M

    Pentair Mastertemp 400 Screen problem

    Its open with heat on or off. Sounds like bad relay.
  10. 20210718_111358.jpg

    20210718_111358.jpg

  11. M

    Pentair Mastertemp 400 Screen problem

    Oops. Ok, it measures 26v regardless if heat is on or off.
  12. 20210718_110337.jpg

    20210718_110337.jpg

  13. M

    Pentair Mastertemp 400 Screen problem

    I have a multimeter. The relay the power lines are tied into is on the far left. Not sure why so many wires tied into that relay... I measured voltage from the black to red wires here with and without the system calling for heat. Shows 240 all the time regardless if heater is on or off.
  14. 20210718_104449.jpg

    20210718_104449.jpg

  15. 20210718_104412.jpg

    20210718_104412.jpg