Recent content by MAKeller

Can someone tell me where this project is documented?

That's right, what happened to the usual P/S? I wish Hayward would update their manuals!

Please see the attached picture

Yes, I would prefer ladder/loop diagrams as I am a classically trained Electronic Engineer. At this point all I can do is try to use the P/S terminals. I think they should have been labeled P/S, Remote. Thanks so much for your help. How can I buy you a beer?

The P/S wires terminate in the grey wire nuts. I believe the Heater Reader Remote "Fireman's" switch is just a set of dry contacts. Normally Open.

Heater Reader

I am using Heater Reader.

There must be something Im missing. If the P/S wires with the grey wire nuts are used as a firemans switch, there must be a remote jumper or remote setting in the controller. Otherwise the P/S connection would have a jumper on it?

Ha ha if only it was that easy. The manual is very out of date. They havent used those controllers in 10 years. They just keep using the same old drawing year after year. I attached a picture of the newer board. They now use the P/S connection on the OEM ICS AR7803. They now a 3 pin connection...

Where to install remote or "Fireman's" switch on Bulitright Heat Pump Controller. Manual for the model 115 or 135 is no help.

Where to install remote or "Fireman's" switch on Bulitright Heat Pump Controller. Manual for the model 115 or 135 is no help.