Recent content by mabrahamson

When should I turn the SWG back on? Should I wait until FC levels have drifted back to normal or is it OK/better to let it run before then?

After two days, OCLT passed this morning and water looks clear. Now to thoroughly clean the ladder before putting it back in and using the pool.

I didn't lower the pH before the SLAM. It's a little higher than ideal, right?

Just ran another FC and CC test. FC is at 20, CC at 0.5. Amazing how accurate Pool Math is with its suggested amount!

Hi folks, After reading through this thread I ordered my TF-100 test kit and ran my first tests this morning. Results are as follows: FC: 1.5 CC: 0.5 pH: 7.8 TA: 100 CH: 175 CYA: 50 SALT: 3000 I used Pool Math to figure out how much chlorine to add to begin my first SLAM. Added the...

Planning on it once my test kit arrives and I can post real numbers. I just also screwed in my Hayward skimmer and am waiting to see if I can find some plunger valves before I cut the liner. Of course the ones I saw on Amazon yesterday are no longer available. I should have ordered them when...

Just wanted to thank the OP for starting this thread and everyone who has responded so far. I'm a newbie with the same problem with my Intex 18' x 48" Prism pool (green, cloudy water) and have been reading up on the discussion. I just ordered a test kit today and can't wait to get some...

Hi folks! New pool owner here: Intex Prism 18' x 48". I've been gathering as much info as I can from here and various other sites to learn what I need to make sure the pool functions well and will last for many years. Upgraded to a sand filter pump and saltwater chlorinator (haven't put the...