Recent content by lland

I have a Hayward AquaLogic system. It controls 2 valves and has 4 relays. I have two valve actuators connected, they're wired directly to the board. One relay is used for the pump and one for the lights, so I have two free aux relays. I'd like to automate turning on the vac (turn off main...

Same clock issues with my GLX-PVB-MAIN. Losing 5 hours or so per day. Found this thread and ordered a couple of capacitors and clock chips (cheap enough that I ordered 2 of each) from Digikey. Changed the capacitor yesterday (old one looked a bit charred). BTW, there's an arrow printed on...

Again, thanks. Installed the pump and it works perfectly. My only installation issue was trying to figure out how to program the pump for only two speeds until I realized the AquaLogic system handles everything.

Thanks for the quick and helpful response. LL

Hi all, I have an AquaLogic system (software rev. 2.95) and just purchased a Hayward VS3206VSP pump. I know the AquaLogic will only support two speeds but I'm having a little trouble figuring out how to wire the pump. I searched and read just about everything I can find but I'm still...

I realize this is an older thread but I added one of these to my AquaLogic system (I have a whole house protector but figured it wouldn't hurt): Intermatic AG3000 Surge Protector: Amazon.com: Intermatic AG3000 Surge Protector: Home Improvement They say this is made for HVAC systems and the...

Hi, mine makes a hissing sound when the water level is just barely below where I have it set. The valve opens just a little bit and the water hisses as it flows through the small opening. While it's hissing, push down on the float to open the valve more and I'd guess the increased flow of...

Well, that makes it easier (and saves $50). Thanks. Nope, no check valve now, and no check valve going forward. New to pool stuff. Great resource!!! LL

Thanks. Just want a check valve between by chlorine generator (Hayward T-Cell 15) and my heat pump (Hayward Heat Pro HP21404t - 140,000 BTU). LL

I'm looking for a 2"/2.5" check valve with a 1/2 lb. spring tension. I bought a Magic Plastics MGP080120H but that ended up having a 2 lb. spring. There are a number of options but I can't fine the spring tension listed for any of them. Does anyone know the answer for the Jandy 7305 or...