Recent content by Lagunas2k

CYA is around 55. I need to bring it up a little. I think I'll just a few different methods and check along the way. I've now been able to figure out how to control the spa makeup line. I've shut that return about half closed, and will test both the spa and the pool over the next week or so...

Thank you! That was exactly it. Now given the aeration is actually probably minimal given it’s not spilling over very much, is there any merit to simply closing that valve about 75% so the spa return is minimal and having it circulate all day vs. running 100% to the pool and activating...

Hi Everyone, I've read through many of the threads on this, but for the life of my can't figure out how to do this. My pool has an attached spa with an infinity edge spillover on two sides of the spa, the water line is only about 1" lower, so not a very large drop. That being said I believe...

Thanks for the info. I was under the impression the range was supposed to be 1-3 for FC, but if there is no harm in going 3-4 then it makes a lot more sense. I'll start with these and see how things go. Thank you.

Just fired my pool guy after six months. Bought myself a Taylor kit and just jumping right in. Thanks for all of the info so far everyone. Here are the basics: 15,000 Gallon - Mini-pebble, plaster pool. In Ground Pool and Spa, small baja. Salt water generator and VSP pumps My PH was at 8...

Thanks everyone. I was able to figure a few settings out to get a round about way of getting what I wanted. Have setup a low speed for the filter jets so that once the heater is done heating it can go down to a lower flow. Same with the booster jets, I have setup multiple levels of RPM's to...

New pool owner here. Been reading up as much as I can but trying to figure out if I have a way to adjust this situation. 37x15 pool with inset spa about 10x7. I have all Jandy equipment, hooked up to Aqualink 3.0/RS6 2 VS Pumps and a water feature pump. I have a total of 12 jets in my...