Recent content by Klorenzini

Sorry it took so long to get back to you. I was out of town for a few weeks. I reset the system. Turned the heater up to max and everything works now. Thanks

Thanks for your reply. However, the heater is set for max heat but it ignores the control panels set temperature. Heater set at 100 control panel set at 96-heaters runs until 100.

I have a Pentair intellitouch indoor control panel and a wireless remote. Both will turn on/off my heater but the heater will not respond to temperature settings. The only way to get the heater to recognize a temperature change is to adjust it from the control panel on the heater itself. FYI...

ALL WORKING---Erased everything and reprogrammed from scratch. Thanks for your input

I tried "getting image from outdoor" but I got the same set up. My last resort seems to be erase EEPROM ALL and start from scratch.

I just replaced a intellitouch I5+3 personality board and motherboard with an I9+3 so I could add additional aux circuits. After startup with the new I9+3 board the display only recognizes the original 5 Aux circuits. It wont show the additional open Aux circuits. menu-set up- advanced-circuit...