Recent content by Karenleone19

  1. K

    Motherboard

    Jim thank you so much for your help the pool is running! Rpm wasn’t high enough and one of the schedules was set up wrong. Much appreciated i learned a few things for sure and one is that there are still really great people out there, willing to help others. So thank you again Karen
  2. K

    Motherboard

    I sent you email with some info just now . Shows auto with pool under it
  3. K

    Motherboard

    Hope these pictures come thru. I reset everything on panel with the Pentair customer service pool turned on then off within a minute there’s a fan sound that stays on when pool goes off. Still can’t get it running
  4. K

    Motherboard

    Jim I sent you an email just now
  5. K

    Motherboard

    Hi Jim I just got off the phone with pentair we got the pump and schedules corrected, but the pump goes on then turns back off within a minute. We are baffled
  6. K

    Motherboard

    Hi Tom I was on the phone over an hour with pentair; the pump goes on then within less than a minute it turns back off again. We can’t figure out what the problem is
  7. K

    Motherboard

    Hi Jim attached are pictures of what panel looks like after I went thru the steps in conversation #16
  8. K

    Motherboard

    Jim I’m going to try all the things you listed in conversation number 16 when I get home from work today.
  9. K

    Motherboard

    Jim, Yes I saw your post #9, as far as any message saying “remote doesn’t match”; I don’t recall seeing anything like that. I did have to do a wireless address search to get remote to talk to panel. Never had a message asking to transfer info from remote to unit. The lights work in the pool...
  10. K

    Motherboard

    Yes there is a click sound. I replaced the mother board 1) couldn’t see the display 2) after speaking with pentair trying to get panel and easy touch remote to communicate they told me I needed to replace the motherboard This is what the pump says now
  11. K

    Motherboard

    The lights are working when I press Aux button
  12. K

    Motherboard

    Ok so I got the pump to say display not active, what next? The pool still doesn’t turn on.
  13. K

    Motherboard

    Jim and @ogdento, thank you so much for your input. I’m going to try these things when I get home from work today. And will let you know if this works. And yes I still have the old board.
  14. K

    Motherboard

    Jim Here are pictures of my pool pump
  15. K

    Motherboard

    Hi Jim Thank you for responding. I had replaced the mother board because it was not communicating with the remote. I hooked all the wires up in the same places that were on the previous board. I then got the two communicating but obviously missed a step. I went thru the whole test thing all the...