Recent content by Jvrpants

Now I am considering it may be human error on the renters side. I am at a loss as to why it it keeps going into service mode when they use it.

Thank you for the reply, we did check the control board and the service heater mode light was on when we checked it today. It seems like the renter left it like that. None of the LED sensors were on We did turn on the machine and it does call for heat, ignites, shut off when it reaches the...

The heater does turn on, runs and then the renter tells us later on that the service heater light is on. We are thinking it has issues igniting again once it goes into standby mode once it reaches the desired temperature. This has happened 3 times so far and each time it has used 5%. The panel...

How much difference is there between an aftermarket and an original pad?

Alright so the heater seems to be running pretty well but our membrane pad is not functioning. We are thinking it got burned out. We are jumping the pins on the circuit board with a wire and they are functioning normally.

Yes we do have gas in the tank. The heater did ignite and stayed lit during the short time we had it on. We are going to be testing it to make sure it runs as it should.

So we opened part of the gas valve where the electro magnet is and we moved the plunger in there up and down and it does move and looks clean. We then connected the electric magnet directly to TH and TR the magnet was functioning and picking up the plunger when being called for heat. The on and...

It is most definitely on. We trie it and the gas valve made a repeated clicking sound when called for heat then stopped and it did not ignite.

We were able to measure the Ohms of resistance on the ignitor and it was good. We do not have a manometer at the inlet of the gas valve. We measured the voltage of the gas valve and there was 24 VAC when being called for heat on the left side of the "on/off switch. On the right side of the...

Here are some pictures and yes we were able to get it running like normal with replacing the transformer. The red regulator is a Emerson-Fisher regulator and that belongs to the gas company. The secondary green regulator is a sherwood. We had a tech come by today to do a free check up and...

I wish I was a repair a technician because if I was I would not be posting messages on here. I am a pool owner and the heater is at a vacation rental and I do not always have access to the home when it is rented. We were able to get the heater running properly the last time by putting 115/230...