Recent content by Jkhook70

Thanks, Jim. Actually, I just went out to the controller and realized that although I had the Intellitouch set at 20%, the "Enable" was off. I turned it on and it immediately solved the problem! I think it must be my age!! :oops: Thanks again, Jerry H.

I have a 6 year old 22,000 gallon in-ground salt pool with all Pentair controllers, filters, pool sweeps, etc. Up until this year, everything worked well. This year, when I started it up, no matter where I set the IC40 sanitizer level with the Intellitouch panel controls, the level lights on...

Just curios - what kind of chlorine did you use, regular bleach or pool chlorine?

You swam with the FC at 25-28? Sounds uncomfortable, to say the least!

My 2012-built concrete/colored plaster (gray) salt water pool operated fine in 2012 and 2013 with the SWG. I didn't have to add any liquid chlorine at all either year. However, 2014 is a completely different story! With my SWG set at 100%, I have to add liquid chlorine all the time. It is as...