Recent content by Jimbydude

  1. J

    BL100 pool controller issue

    Unfortunately not. I've ran out of solution so I'll have to get more before another attempt
  2. J

    BL100 pool controller issue

    So tried 1 point calibration. 1. Entered Cal and held menu to clear. 2. Entered cal again and controller asks for 7.01 3. Place probe in solution 4. Say recognized and then wait before going back to main display. Heres strange thing. 1. While still in 7.01 cal and before wait appeared the...
  3. J

    BL100 pool controller issue

    I'll try that today, Cheers
  4. J

    BL100 pool controller issue

    Yes, although ir says save and seems to exit cal mode automatically as it goes back to main display after 1 ior 2 seca
  5. J

    BL100 pool controller issue

    Double point calibratio. 4.01 and 7.01. Controller recognizes both and says save on display. I then placed into pipe, probe should sitting at least half into pipe. Display never goes above 4.03. Tried reset controller. Removed from pipe and placed into new 7.01 sol assumimg that it should read...
  6. J

    BL100 pool controller issue

    New from manufacturer with cap with fluid to prevent drying out.
  7. J

    BL100 pool controller issue

    Saw some threads relating to the Hanna BL100 PH controller so hoping someone may have some isights into why I cannor get this working. it calibrates just fine but when in pool line always reads about 3.9/4. I have tried calibration and then immediatly dipping back into 7.01 sol but reads low...
  8. J

    Strange water lines in pebble tec

    Hey, Thanks to all how replied, I really appreciate everyone's time. To answer Dirk, the surface of the pebble is definitely got hairline cracks, how deep I can't tell but as couple of you have noted most likely water is running down those from above and the stone at that point is already...
  9. J

    Strange water lines in pebble tec

    So what does that mean as far as integrety is concerned. Best to leave it ? Thanks for the reply
  10. J

    Strange water lines in pebble tec

    Hi, I just did a partial drain of pebble tec pool,not quite half but i noticed that in one area the water was not drying as fast, leaving what looks like cracks. On closer inspection i def see what look like lines of very hairline crack. At least i can see that some of the small stones are...
  11. 20180903_163019.jpg

    20180903_163019.jpg

  12. 20180903_162959.jpg

    20180903_162959.jpg

  13. 20180903_162926.jpg

    20180903_162926.jpg

  14. J

    No water getting to Autofill (standard toilet cistern type)

    Dirk, you are the man, I got wife to check it and sure enough it was turned off. I can only assume that they turned it off when replacing sprinkler and not back on !!! In the years I've had pool I've never had to think about it ! Thank you so much as this was obviously a worry, and not too...