Recent content by Jgam21

Main pool breakers are located in house main box, which then feed to a separate box outside beside the omni control cabinet. This separate box has on/off switch which feeds the omni control cabinet (this outside box also has a gfci). This is how the pool builder installed. I am going to wire...

See attached files. Question, the single speed pump I replaced with the VSP was wired to the high voltage relay. Can the VSP use this same wiring to the HVR? I am thinking maybe the relay is off when omnilogic reboots and that is why the pump connection is lost? The pump is a SP3202VSP...

Yes, comm connection 3 wires, common, a to 2 and b to 3. dip switch set to all five to "off" . Also, I unplugged the display at pump. Then used single plug to wire only the omni to the pump with 3 wire connection shown above (i.e. display on pump is now disabled). Should the pump display...

Yes, I have a call into Hayward customer support. Yes, I installed VSP myself. Basically, just removed old single speed, slid new vsp in and connected same 220v leads, added comm cable back to omnilogic controller. Also updated to latest firmware for MSP and MP.

Replaced a single speed filter pump with new tristar VSP. Upon initial configuration of vsp filter pump the controller recognizes the HUA. AFter selecting the HUA and saving the new config, the controller automatically reboots. Once rebooted the controller does not find or recognize vsp...