Recent content by JFQ

So. the intermittent 120/121 errors return! I cleaned the year old 1400 cell although it had minimal scaling. There was a little corrosion at one of the DC cord connections to the cell. The DC voltage at the cell was a bit high at 35v while the error codes were present, but while there was no...

An update... my local Jandy service guy was also stumped. New 1400 cell, new Tri sensor, new DC cord, new PCB. He asked around amongst his peers and someone suggested raising the salinity to 3500 ppm or so. This seemed to me like a shot in the dark as it had worked reliably for several years at...

120 v

Three prongs. The cell works for a time then the errors reappear.

I have an Aquapure 1400 system that is in its fifth year of use. I experienced an intermittent General Fault error code (120 mostly, 121 at times). I replaced the cell, tri-sensor and DC power cord but still got the same error codes. A local Jandy service guy then replaced the PCB power...

Bought this at Lowe's in 2013 for under $300. Have been very happy and bought another for the other side of the pool this year. Have base weighted with 250-300 pounds of sand. http://i1164.photobucket.com/albums/q565/jfcq/7-13g_zpsrwsxl2qx.jpg

http://i1164.photobucket.com/albums/q565/jfcq/7-20_zpsjiilew6q.jpg

http://i1164.photobucket.com/albums/q565/jfcq/pool%20pix3_zpsmancihv0.jpg http://i1164.photobucket.com/albums/q565/jfcq/pool%20pix_zpsfvasxtsw.jpg http://i1164.photobucket.com/albums/q565/jfcq/7-20_zpsjiilew6q.jpg

I don't have Pentair. Have you tried calling Pentair customer service? They may be able to talk you through it.

test

Yes, I also put it in service mode but was unable to turn off the pool lights from the panel, although other features were able to be controlled from the service mode options. The only reason I mentioned the flow sensor replacement is that the Aquapure fault was intermittent and a bad...

Hi folks. First post here. My system, described below, was built in 2013. Service guy recently replaced the Aquapure Tri sensor for "No FLow" alert. Aquapure now working. Later that same day, the pool LED lights turned on, ahead of the normally scheduled time. They will not shut off or respond...