Recent content by jbslade82

We had a whole house standby generator installed. It has some isolation relays built into the automatic transfer switch (Generac 200amp ATS). These are 24 volt wiring meant to break a connection on an A/C unit when the generator is stressed. I believe this is doable on our pool heat pump...

Appreciate everyone's help. I ordered a vacuum setup which will be here Thursday. I'm going to constantly run my pool robot until then and switch out the DE a couple times a day. Sounds like I just need to work at it constantly. I don't plan to use any flocculants. Again, many thanks!

I don't have a vacuum, I only have a pool robot which I have been running all day today and washing the filter every 30 minutes to get anything at the bottom. I don't have a trash pump unfortunately. I can vacuum to waste though. I might have to invest in a vacuum then. Is there an additive...

Not sure this is the place for this. I have never had this happen before. But last night it rains many inches very quickly and flooded an area around the pool, the patio drain got plugged up and a lot of dirt ended up in the pool. I have a DE filter and have switched the DE out twice today...

We have lost a couple, and the others are a big ugly. What is this part called? It sits on top of the joints around the steps. Thanks.

Very helpful, thank you!

Good point, I will check that out. Does it matter if that window is a garage window?

Yes, I need rapid heating. Best of both worlds is that I have the ability to heat up quickly. Or run the heat pump to maintain temp when the temp is appropriate more efficiently. Our weather can be 50-60 degrees for 3 or 4 days during the week, then 80 degrees on the weekend during spring and...

Hello, I'd like to add a gas heater into our current heat pump setup. With the climate in central new york it would allow me to have the best of both worlds. Use the gas in the spring and fall, heat pump in the mid-summer to maintain. My idea would to use one or the other and change the...