Recent content by JackHarkness

I'm not here to like spread any Aiper negativity. I would just say as someone who had 3 units (now just 2 units) - and all 3 acted the same - this appears to be a real problem and not just a 1-off. Now, clearly some of us are here with pools that it works amazing for. I think that's...

Exactly what I thought also. It does seem to be stopping soon. The behavior of it is sadly very odd indeed. Happens with both units though annoyingly. I wouldnt say its particularly sloped. Sure there's some curve to the edge but the unit is stopping way too soon. Not to mention it seems...

Hi - I wanted someone with a S300 to comment! How does it perform? Also @tcat Here is the FULL timelapse video. Only 1 minute is cut out - it was dropped on the TOP RIGHT EDGE of the pool - floor only mode. It made its way to the middle-ish of the pool rotated - then went back to the corner as...

I mean mine is literally a rectangle, and it misses a good 25%. I'll timelapse it - but it leaves me incredibly unhappy as a good portion of areas are uncovered to the point I have to manually vacuum also.

Ok none of mine do that. That actually looked intelligent....I may have to timelapse...

Thanks for this - but again I wonder compared to what is considered the best - like a S300 - how it functions. Are you saying owners of those more expensive vacuums have to do 2-3 cycles also? I think it may be unreasonable to think I'm unreasonable if you haven't personally tested the higher...

I bought them as gifts as they were the rave at CES (where I was). In hindsight, I should have perhaps tested one for 30 days. I have returned the 3rd one (it was so bad that the person gave it back, LOL) and the 2 are currently with me still within the 30 days. I decided not to gift the 2nd one...

Can you show how you installed these? Confused what you mean by cutting lip off? Mine seems to sometimes* get stuck on the drain Again - I could understand having 1 dud. But do you think it's plausible I got 3 duds? I bought 3 of them - and have 2 for myself. All 3 have the same issues...

Admittedly...I have been avoiding that. Its never a fun process...I hate the stupid nut on there and always find it super annoying to take the big clamp off .. I figured it was probably that. Before I do though...I have to admit I have done cleanings before. The cartridges however are well over...

I believe when I had it clean which was a while ago a long while ago like almost 1 year....it was like...5...? If I recall

Hi all...not new here. Recently noticed my pool water seems lackluster...admittedly I did skip brushing for a week...but I got it cleaned up...still...the pool is cloudy. TA 88 CYA 80 - SWG SYSTEM pH 7.2 Chlorine: 14ppm currently due to adding 44oz chlorine liquid yesterday as a test for OCLT...

I have 2. Both do the same thing. It also likes to lift itself a lot and turn in random directions. I have a rectangle pool with curved walls in the corners. Neither of them properly do the wall. They seem to stick to doing the floor even when I made sure its the correct Auto mode. I see it...

Hi guys I have this vacuum. I strongly urge against it. I was excited to get it...and all it does is aimlessly bounce around like a Roomba in the water. It misses spots...and overall does a poor job for my 11k gallon pool...shocked at their advert. The smart navigation feature is...