Recent content by hexabc

The code in github is up to date. I added a second transducer to monitor SWCG's supply current: Monitoring CircuPool RJ Plus SWCG.

"Our understanding is that chlorine disinfection byproducts are associated with a ton of issues, including higher incidence of cancer." Aren't those concerns about drinking chlorinated water?

If I did a plaster job, the result would probably look similar. But I had never done it before.

It's a good point about CYA - the water leaving SWCG is probably much more aggressive (oxidizing) than what the target FC and the CYA level would suggest.

What's the chlorine contents right after SWCG when the target is set to 7 or 8 ? Is it close to the target or rather much higher, something like 15?

With a booster pump and Polaris cleaner there is no reason to run VSP at a higher speed during cleaning intervals. When selecting the minimum VSP speed just make sure that your SWCG's flow switch is satisfied and the skimmers are still effective in collecting debris from the pool surface.

A mesh cover may get destroyed by the weight of snow if the water level is too low. This is the reason why I don't lower the water in my pool below the returns; instead, I blow the returns out with an air blower and plug them. The minimum water level for my mesh cover is 18 inches below the...

Why don't you properly winterize your pool ??? :LOL::D:p Ah, you think it can't be so bad as in this picture:

What is shock level?

Yeah, the subscription fees would be too much for me, and software should be free. I spend all my allowance on hardware.

I ran your equation through AI and it coredumped :mad:

I would look into confirming that your digital tester is correct. Get the Taylor's K-1766 drop test. It's currently available on Amazon at $31.

I ordered for my A&S pool several dozens of various sizes plugs on Amazon a couple of years ago. Didn't notice any quality problems. One of the two skimmers has a connection to the drain, so that one needs a combo of two plugs separated by a spacer; another spacer is between the upper plug and...

We have a free-form RuggedMesh Meyco cover, bought in 2017 as a replacement for a 10-years old non-rugged mesh, also from Meyco. The RuggedMesh acts as a filter for dust/debris, which dries up on top of the cover and can be easily blown off. We open the pool to a much cleaner water than with a...