Recent content by gbhumphrey

My pool size is about 25,000 gals. I have a Pentair Filter housing CCP320. I USED to have a CCP420, but it cracked and the pool servicer replaced it with the 320. it seems my water was better wit the 420, so can I get a new lid that taller and the filter rack for 420 sized filters ? Would that...

My Pentair Mobiletouch 2 screen is starting to die. Like with all Pentair equipment expensive, $1400 to replace. Is there a newer type of control available for around the same price or can I get the screen somewhere?

Thanks all, I'm looking at replacing that surge card next. I'll update when I do.

Hi, I have the same issue. The Screenlogic app shows IC 60 reports 0 salt, but CAN change the % settings. But my power center doesnt have a Com port connection. The Intellichlor plugs right into the Com board in J7. See pics. Am I missing something? AFAIK, the Salt level never worked. The...

Ok, got a new flow switch, it had 4 wires. There was a wiring diagram that showed how to connect 3 wires to it. However, this didnt fix it. In fact, on the Amazon page, it says "This part will not fix low salt readings" .

Hi, just circling back to this finally. Do you have a link to the "3 wire flow switch" ?

Oh. Well. Here is the problem. Its never been cleaned in 2 years. So I cleaned it.

Hi Jim "The salt level reading zero is a know issue with the IntelliChlor" - UGGGG this is the one piece of information I need on the ScreenLogic App. Pool and Spa separate controls, got it. My spa overflows into the pool, it's all connected. Yeah I turned everything off and back on a couple...

Hi Jim Yes, I can operate all lights, pumps etc from the ScreenLogic app, so the RS-485 Bus is working. I have internal board Pentair Water PCBA 521593. The antennas plug into that as well. Sure seems like all pins of the 4 pins of J20 are connected. I just jiggled all the wires that were...

Hi I have a Pentair IC40, and it seems to work, lights are all solid green, it just doesnt communicate with the Screenlogic App any longer. I know it did at one time but cant say when. The App controls do nothing and in the Delays and Alerts -> System Alerts I see " Chlorination: Communication...

I'm sure Ill be giving Pool Tone a try. I have NO faith in these GloBrites. My question was really more about what could cause it to turn brown like that? Did it explode? Was the pool water too warm? I've had others fail with the seal broken and water is in it, they didn't look like this...