Recent content by Fshine

Thank you - all equipment is working now as I was hoping for! Really appreciate your help. Now my next focus is on how to enable the lighting properly - haven't figured that out after multiple combos. Thanks again!

@ajw22 I apologize for my naivete with this stuff and appreciate your assistance. I went back through the configuration and it's clear I have work to do on identifying which valves control which items in the system. Having said that, I also confirmed that the heater is not being powered unless I...

Apologies, I 'misspoke'. The flow switch is connected where you have highlighted and I will double-check that I configured that properly in the Omni. Good to know re: HVL1. The issue is that I also installed a new Hayward VSP pump that I removed from that relay and had to wire directly to the...

@ajw22 Thank you for the info. I do not have a multi-meter so will need to get one to confirm. For the moment, assuming the relay is properly opening and that it's a configuration problem, I confirmed that the actuators were both set to the 'ON/ON1' positions. In the panel itself, I only have...

Hi everyone - Been going through all the various threads and am just not knowledgeable enough to know if this has been answered somewhere so apologies if it was. I have a mess of pool equipment and upgraded my panel to OmniPL from a (very) old Goldline controller. I have most of the Hayward Omni...

Thank you for the clarification. I confirmed I am version 2.4. It did come with the comm cable and additional terminal block. Since I saved on the cost of install by doing it myself I think I might use those funds toward OmniPL to bring the system into the modern era and take full advantage of...

@1poolman1 I ended up waiting out last season and now have the Hayward Tristar VS pump. The plumbing seems straightforward, but any insight into how to connect it to my old Goldline control panel? And how do I go about programming the system to operate the VS pump? (I believe there is an...

Thank you. I will likely get the TriStar per your recommendation. Much appreciated!

What Hayward VSP would you recommend all things considered? I have an aqua connect goldline board. (I was considering the Omnipl conversion before having to replace so many other parts this year). I’m quite handy - is the replumb due to inlet location vs old or diameter of new?

My system is a Goldline / Hayward c. 2005. All equipment is branded either of those. The pool and equipment is indoors, so much of it has lasted longer than it otherwise would have. I am open to buying the “right” brand, it’s just been one of those seasons where I have had to replace a lot of...

Thank you both for the information. So the CaliMar would require a replumb but otherwise would work for my purposes? What would you recommend given the “even” qualifier on the CaliMar?

I have a pump housing c. 2005 that has bit the dust (see pic). I replaced the motor in it a couple of years ago. If I were to get a current housing from Hayward, would I have to redo surround plumbing or would this plumb in fine? Any chance of salvaging the newer motor and just replacing the...