Recent content by flubberhead

Running the irobot to mix it up did the trick. Now at 3100ppm and generating happily. Thanks, all!

I'm using the 25ml tube and testing at 10ml per the instructions. The kit is 3 years old. Water turns milky salmon red after 9 drops, consistently after 3 tests. The only thing I can think of is that the salt water isn't mixing and sitting at the bottom of the deep end (i.e., not getting to...

Taylor K-1766

no salt visible on the bottom of the pool, so I think so.

Just opened the pool (40x20 in-ground) this week, water temperature is currently 72f. Hayward Salt Generator was reporting 1800ppm at opening. Added 4 40lb bags of Morton's pool salt, and then tested it again 2 days later. Still 1800ppm. I then tested the salt levels with the Taylor salt...

It's running around 7.5-7.8 amps @ ~22.8V.

Just replaced my T-cell-15 when I realized the low reading was a bad cell. Chemical test and the SWG both now show a reading of 4600-4700 which is very high, but the SWG does not have the High Salt light on and it continues to generate after 72 hours. Chlorine levels are also remaining stable...