Recent content by finethreads

Replaced the main board. Thanks to @ogdento for his help on the board. Also replaced non working wired remote and damaged panel to remote wiring. Everything has been working flawlessly for two weeks now.

Traveling all summer and won’t return until end of August. Ordered and received a S.R. Smith Sealed Steel handrail before my departure. Arrived all nicked up due to the unattached escutcheons rattling around inside the box. Very nice handrail. Will order another one upon my return.

Well, I found the bonding wire. It was 30” from the edge of the pool and about 4” down in the sand.

Thanks for all the helpful replies. Here are a couple of photos of my pool where I am installing a handrail. I will check farther back under the pavers for the bonding wire. I can also bring over a new wire (70' run) and bring it to my handrail. I am thinking of placing the handrail just...

I am in the process of installing a handrail for our sundeck. I dug a hole under the coping to the pool wall. I am looking for the bonding wire so I can ground my two bronze handrail anchors. I dug down about a foot down and away from wall and see no bonding wire. Am I looking in the right...

It’s a brand new Intelliflo, brand new cable. Nothing else works when connected to the J20/Com Port.

Hi Jim, all I have connected to the J20 Com Port right now is the Intelliflo. The screen display on the Intelliflo does not show Inactive like it used to.

Well, after experiencing full functionality with regard to my screenlogic and wired controller connected to one of the com ports on my SWCG expansion board, intermittent problems started occurring, I.e. the pump would not turn on according to schedule, wall control would not always work, and...

This should be my last post. I pigtailed the wires coming from the screenlogic and wired controller along with a third wire to connect to the com port on the SWG board. One of the problems I saw was that when they hooked up the wired controller they used a pretty thick 4 wire. When they put...

It’s about 5 years old and located on our screened porch. We live just off the beach on the Florida panhandle. Can be brutally humid With salt in the air. I am going to try reconnecting the wired Controller. The previous connection was a little messy with bare wires sticking out from the...

Okay, I left the wired control pad disconnected and just reconnected the screenlogic connection. Everything is working perfectly now.

I thought I would try something. I removed the terminal block from one of the SWG com ports located on right side of SWG board. The wired remote and screenlogic were connected to this com port. See picture below. Now the pump works fine when connected to one of the SWG com ports. I’m...