Recent content by FinallyaPoolmom

My issue ended up being electrical. The keypad power was not connected. Therefore it was not allowing us to use the keypad. Once we took that apart it worked for use.

I grew up with a sand filter so I remember what it sounds like. We installed a pool in the fall and have used the filter balls since. It has always made a different sound. So I am curious if the filter balls are just louder. It isn't quiet like I remember that sand filter. The filter balls...

I grew up with a sand filter so I remember what it sounds like. We installed a pool in the fall and have used the filter balls since. It has always made a different sound and so I am curious if the filter balls are just louder. It almost sounds like a gurgled piece of gravel. I tried recording...

I am sorry I just saw this. Did you ever get your keypad to work?

I had this problem when we turned ours on over the weekend. This morning we took the panel apart to double check the wiring and the keypad harness wire was not plugged in. Connected and put everything back together turned unit on again and now it is up and running. Maybe that will help you.

Unhooked the panel and the keypad wiring was not connected. Connected it powered it up and now is up and running!

Yes and it does nothing when pressed. I have held down the buttons and nothing happens. I have pressed buttons and nothing happens the screen just stays on Standby 100%.

We opened our pool this week (installed it in October). Turned on our Jandy Tru Clear salt system added salt yesterday as well. My problem is the reading stays on "Standby 100%" I cannot push anything to change that. I have watched the videos. So I wonder if the cell is bad to start with would...