Recent content by doclip

It's only been running for 2 hours now...salt level is about the same as before (5000ppm)

Thanks everyone for all the help! I followed the instructions (open filter to de-pressurize, cut the power, remove the old one, put new o-rings, lube them, and put the new unit in). Here are a couple pics of the 6-year old unit which was never cleaned. I'm going to keep the old one and practice...

I'm not home now, this is the picture I have from when I purchased the place... I can take more pic when I get back home

Apologies for me being MIA... I ordered a new IC40 because 1) I don't have time now to take care of the pool myself...(hopefully in near future) 2) I thought it's better to have extra one as the original one is almost 6 years old (and probably never cleaned) I see in some YouTube videos, that...

Date on the cell is Nov 2017, which is when the whole pool was installed.

Pump runs from 9am-2pm daily. Water looks very good to my eyes (all clean and clear) Jim, Good salt light does not flash...as you suggested to set it to 50%, it turns on for ~2min and off for ~2min

The pool has irregular shape..I measured the length and width ,which are 23 and 19 feet...Depth is 3-5 feet...so overall the volume is smaller than 23*19*4*7.5=13000 gallons. I tried the 50% suggestion. When setting the output to 50%, CELL led stays on for around 2:10 minutes, and off for...

Here are the pics. The 'Good' led is flashing, app reads 4400 salt level. The CELL led goes on and off with no particular interval. He mentioned that sanitizer has no output, when he was debugging it the 'sanitizer output' leds were all off...but today it's back on again. He also checked the...

Hello, I just joined the forum due to abudance of the knowledge here... I'm new to my pool, purchased the property a couple years ago. Pool was installed in 2017, Pentair system. I have a pool guy (through a company) who services the pool once a week. He mentioned the salt water unit IC40 is end...