Recent content by dgibby

Good to know. Thanks. I assumed that everyone was using the block since the instructions in the test kit said use it daily. I see many post about people adding chlorine every other day or so and assume that was the test they were using. I’ll start using the other one and mainly use the block to...

Ok. Good to know. Guess I’ve been using the wrong test for my pool math input.

Yes, from the block. The pro kit came with a recommended testing sheet that says use the block to test chlorine and pH daily and only check with the powder, the free chlorine, once a week. But then I see people are putting chlorine in their pool every day or every other day, so are they doing...

So why use it to test daily as recommended and do you even use the number in pool math?

This might be a dumb question, but I have the pro kit for testing. There is the block thing that you test chlorine and pH daily. Then with the drops and beakers, there’s a free chlorine test and a total chlorine test. What chlorine test is the one in the little block with ph considered? Free...

Thanks! I appreciate all the information and will read through it.

I figured I’d give it a go with the tablets see how it goes. Didn’t want to start the CYA out too high if not needed yet since the tablets are also adding it. If it doesn’t work out, I’ll switch to a SWG since water changes in a fiberglass pool are not very easily done.

Thank you. I looked for something like that earlier and couldn’t find it. Must’ve not looked hard enough. What’s your opinion on adding the stabilizer since I’m going to more than likely use the pucks? Should I bring the CYA up right away or let the tablets slowly increase it? It’s not swim...

The free and total are .5 It barely turned pink and both test turned clear with just one drop.

Not sure where to start with my new pool. Wish I would have found this site before I started it. Just finished "Pool School" with the pool company and it was a joke. Day one, he cleaned it and poured a half gallon of acid in it and never tested the water. Came back a two days later and cleaned...

Sounds good. I’ll monitor it. I appreciate all your help.

Sorry. I’m a knucklehead.. the pump strainer is staying full. Look at it with a flashlight and it looked empty but it wasn’t. Should I be concerned about the 0 psi at low speed? Ran it through the settings and wouldn’t read pressure until 2000 rpm.

Thanks!

Not sure if it’normal but the pump schedule ended and two hours later the pump has lost its prime (no water in pump basket). Pump and filter are maybe two feet above the pool level.

Just checked it and the speed is 1700 rpm. 0 psi and the pump basket had lots of air bubbles in it and not full of water. Lots of flow out of the returns in the pool and good suction at the skimmer. Shut it down and checked the pump strainer and it was clean. Fired it back up and the pressure...