Recent content by Deltadog

Update: I reverted my intellicenter software to a previous firmware, now it automates correctly.. On another note just prior to the update I notice the Pentair Home App and the Intellicenter was not showing the proper cooling set points, only showing the heating, although the Ultratemp was...

I did reboot, the heat function is working correctly( heating and turning on and off through app) the cooling function is working to turn on the unit but will not turn it off. The below pics are 10 minutes after I increased temp in app. I would assume HP should be off by now.

Not sure if it heats or cools, haven’t ran it long enough yet. I did just try the heat function, it turned on when and off through app like it should .

Interesting enough, when a Pentair tech came out for my last unit, they stated that dint know how I was operating the HP remotely with this connection method and it needed an additional relay? Which contradicts the manual and Pentair HP tech support I spoke with.

I did not, even changed address back to 1 and updated IC. With the manual not mentioning IC automation, is it correct to assume the proper way of connection is just using the COM ports and the yellow/green wire? Manual references the spade connection ?

from Pentair, was issue with my other HP, I swapped out. Installed by PB originally

2.017

See photos. Compressor seems to be running. If I switch the ultra temp to manual, it immediately stops when I increase temp.

Yes

Yes

New replacement

Seems as the compressor does shut off, but the fan continues to run(overnight) never stops.

I reset the controller. Now the ultra temp will turn on when I drop the temp below current temp. If I turn it above it, how long should it take to turn back off?

It was not working on 1 so a changed to 2 to see if I could get working

Yes I have all 3