Recent content by Danor

Ok, got around to the readings yesterday. Here they are. I followed the instructtions and the readings were the same in all cases. I havce a t-15 Aqua-Rite: 2500 89 (water temparature) 25.5 5.45 39P -2400 AL-0 r 1.58 I also measured the salinity with a Apera Tester Kit and it gave me a...

Thanks. I forgot to mention that i did clean it and had it tested. All good on that front.

So my aquarite is giving me a reading of 2300. I had the water tested and it's really at 4000. Before opening up this season I replaced my thermistor because my readings were off last season. New thermistor and still bad inaccurate readings. In 8 years I've replaced the thermistor twice...

Thanks, I will have a look. I thought that 3rd piece was in permanently!

Thanks for the response. Here’s a side view. I had tried a different type but it did not fit. My local pool store only had 2 types so I was stuck with these!

I have 5 of these returns in my pool. I had the pool built 8 years ago and I’ve never really like them. I often have to adjust them as the direction of the water flow changes. My question is am I locked in to these models or can I replace with different types of returns. Thanks

Good point - it is earlier than most years. It’s only 58 - I am a little over eager with the Covid-19 situation. I guess I will wait a week or so. I might order a few to have handy if the situation persists.

Thanks. Just had a quick lunch and headed back out again. I loosened everything, removed the o-rings, greased them and put them back in. Tightened everything. There are 2 unions lined up parallel to the ground and those are no longer leaking. The other 3 unions pointing directly down...

Posted this in water chemistry by accident so I am reposting. I am in Montreal, Quebec. Just opened up the pool. This morning I started the pump and noticed that every union is leaking and it’s leaking at the pressure gauge and it’s leaking at the top of the filter. I’ve had the pool for 8...