Recent content by coryp

Thanks, Added some replies above and will try again looking at the actual heater (no kids waiting this time)

(No children were actually cooked) I just turned on my hayward heater the first time this year via my ps8 remote to the jacuzzi in my inground. And while the water temp read 78F, the kids waiting to get in came in telling be it was so hot. Ir gun tells me it was 105... anyone have the quick look...

Unfortunately the only warranty place by me will only replace dealer/installer installed cells, making the whole process ridiculous. There used to be a service center in driving distance that would check and replace any cell with a receipt,, but they are no longer around. I feel like it's a...

Ebay so the last two were this listing, granted when I got them they were under 300. I didn't expect hayward quality, but I didn't expect them to die at 9 months. In the summer, they run high, like 75% and winter maybe 25%. My pool runs 8 hours a day on low. The previous cell was a glx hayaward...

Or are cells just this terrible lately? I have an older PS8 and a T15. I have had the board redone about 5 years ago and it fixed some high salt readings, but I think I've gone through 3 cells in 4 years recently. One hayward and two off brand. All of them drop one side of polarity first. My...

Yes, everything is Hayward/goldline. This happens regardless if I set the shopping at the control panel or aquapod. I don't think anything is programmed via the heater directly. Both displays read close to the actual water temp, measured independently. The problem is the heater doesn't turn...

hi all, i'm having trouble with my hayward heater control... the other day my kids were in the jacuzzi, telling me it was too hot. I had it set to 96, and when I went to check the controls it was reading 102. I've been watching it for a while now and it consistently overshoots. it does...

got it all going, as an FYI, the new white wear ring that came with the diffuser is shorter that the one that was factory installed... i triple checked the # on the ring vs the one on the parts list, so i'm hoping it's just been updated. seem to work so far...

thanks, sometimes i skimp too much, i'll wait till i can get a hold of all the parts.

so, my 2 spd 2hp tristar has been sounding like it's going on the uphill part of a roller coaster just before the drop. i was hoping it was some debris, but found that the white wear ring had just about eaten through the diffuser. i assume that the impeller was cracked as well, but looking at...

NEW Taylor 9265 Magnetic Stirrer Speedstir Start-Up Pack w/ Stir Bar + Batteries (B004BGPC5W) | Amazon price tracker / tracking, Amazon price history charts, Amazon price watches, Amazon price drop alerts | camelcamelcamel.com Taylor 6190 - Samplesizer, 10 25 Ml, Anodized Aluminum (For 9198)...

i know, super old thread, but, can i ask if this installed easily to a standard hayward eyesocket? it looks like 1.5" MIP and i've never tried to take the eyesocket fully off the pipe fitting... the web images don't look like a connection i've seen, and i haven't been able to scour any...