Recent content by chedlin

Ok, still nothing, so it’s quite possible both replacement drive units have been bad. That said the manual for my model has a much shorter troubleshooting section. https://www.jandy.com/-/media/zodiac/global/downloads/h/h0420400.pdf I guess I’m going to schedule a service call. I’m terrified...

I replaced my iAqualink 2.0 module (with a 3.0 because it didn't cost any more) and the pump shows as "Not Installed" in the VSP setup menu. I have tried two used drive units with the same results. I have verified the RS485 cable is intact with a multi-meter (10V DC between pins 1-4, and...

Found documentation on pins. Green and Red are power, Yellow and black are data: See images linked in AquaLink PDA install.. I've hit a wall

Thanks. The image posted was already printed on the door of my controller, but the RS-485 doesn't define colors or even pins.

Thanks! That test procedure will help a lot as soon as it stops raining! The pump is a Jandy VSSHP270AUT. I do know the owner of a pool builder (not in my city though) that has Jandy contacts if I can tell him what I need. Do we know which pins are the RS-485 data pins?

I think I was the victim of a nearby lightning strike. I had my Aqualink panel iQ20 hard wired to my wiring closet through a burried ethernet cable. My network switch, firewall computer, and Aqualink panel were all dead. My Oasis Dolphin Z5 also died, it was in the water. I'm wondering if...

Hello. We are in the final stages of selecting our pool builder to start construction next month. We have the design settled with an 18' x 40' pool and a 50 sq ft hot tub. I have a few questions. Are Ozonators and or UV worth the cost? I suspect no. I'm tempted to get a modern robotic...