Recent content by ChadJB

Turned off both red valves, as well as the black valve feeding those valves. Also turned off the valve to the puck feeder. Still had water drop but not as pronounced.

Jim, Valve above check valve controls spa spillover rate and a small rock waterfall in pool. Have no idea what the smaller broker valve controls but will see if i cannot determine what it does tonight. When the pump is turned off it does not drain the spa into the pool.

See attached. The water dropped about 8 to 10 inches in 45 minutes.

Correct, spa in use and pump running. And correct only one pump on the pool spa system. The water level drops during the heat process and additionally as you sit in the spa. I would say if it is for an hour and a half the water level would drop 8" or so.

Thanks. I believe the actuators are moving to a fully closed position from what i see. The spillover does stop when in spa mode so think it is the diverter gaskets inside the valve that is allow a slow amount of water to seep from the spa system into the pool.

New pool owner, purchased home where previous owner had pool for many years. I have learned a lot about the system through trial and error but current issue has me stumped. It is a complete pentair filtration/pump/heater set up. Pool and spa combo with spa slightly raised with spillover. When...