Recent content by CGNY

pjt, Thanks so much for your response. I usually add 112lbs of Borax in the beginning of each season as my experience has been that it keeps pH from bouncing. Latest results: pH 8.0, FC 2, CC 0, CH 320, CYA 25, Temp 88, Salt 3,000. Test kit is Taylor K-2006C. DPD Powder + regent to test...

mknauss: Thanks so much for your response. I am not using more fill water this year. I have an electric pool cover so evaporation is minimum. Fill water TA is 40.

I have been practicing TFP Pool Math for years, including using Twenty Mule Team Borax. It could be my imagination but this season my pool seems to be suffering from constant low chlorine along with high pH. I know that the process of creating chlorine via electrolysis creates Sodium Hydroxide...

Hi Allen, Thanks so much for your response. I can see where high salinity would cause heat damage to the tri-plug going to the salt water cell but could it cause damage to the transformer plug and back board? I have no damage to the tri-plug but both transformer plug and backboard were burnt...

Moved from here. I need to replace my transformer as well. Does anyone know if need to discharge the old transformer or can I safely remove a few minutes after shutting down the breakers in the Aquapure? Also, I have noticed several posts on the internet of burnt transformer plugs like the one...

I need to do something similar. I want to control my Stenner acid pump via Jandy AquaLink. Easy enough as I have a spare relay HOWEVER, for obvious reasons I only want the Stenner pump to run when in pool mode (not in Spa mode). So for example, if I schedule the Stenner pump to run periodically...

Hi, I have a Jandy C1900 ORP and pH ChemLink Controller that is around seven years old that has recently stopped recognizing when a new pH calibration number is entered. I am able to enter and save the new number as expected however the system stays on the old inaccurate number and slowly moves...

Hi Ping, Thanks for responding. Single pump services the pool and spa therefore normal pool mode operates in pool suction and pool/spa return. Water chemistry is almost always obsessively perfect. Spa chemistry is identical to pool chemistry while in pool mode, my thought process was when...

All, Jandy AquaLink Touch provides for separate chlorine production settings for pool and spa. Pool works fine however when switching to Spa all signs of AquaPure disappear from status screen which means no chlorine production in Spa mode. Pool was installed many years ago, when I questioned...

yes- I am in the process of locating a chip.

Mystery solved! I have a rev. QQ CPU chip! Rev. QQ will only work partially with iAquaLink 2.0. Despite multiple warnings that the iAqualink needs rev R or later I had just assumed that I had rev. R since my install date was over a year AFTER rev. R was introduced. The Help screen on iAquaLink...

The saga continues. I think I may have a bad unit. Home Screen icons only stick for a short time and then disappear. After that I need to reset the unit (either by cutting power to the Jandy control panel or by toggling the Ethernet/ WiFi switch inside the iAquaLink). Without a reset there are...

Dodger, Rich D & Setsailsoon: Thanks so much for you helpful responses. So this morning I decided to relocate the iAquaLink from outside by the pool equipment to indoors closer (very close) to the WiFi signal. I tapped into the the same 4 color wire that connects to the Jandy Touch Screen and I...

Moved from Here I installed the iAquaLink 2.0 today. All went well with the install, I was able to connect it to my Wifi router and all 3 lights are lit on the device- it took maybe 15 min. I then spent the next 2 1/2 hours trying to get the iOS app to connect to the device. I must have hit the...