Recent content by calsettle

I recently replaced my power pack on my Maytronics Dolphin Oasis Z5 pool cleaner. I purchased a 9995672, my original power supply was a 9995671. My original supply had a light for when the canisters were full and I think another for a timer function. The new power pack has a selector for 3...

Steve, I went and bought the 15 gallon Stenner tank with the 45MPH10 Adjustable pump. I run my pump about 10 hours a day and I wanted to tie the pump into the sam e timer to keep things simple. I'm not worried about any noise this makes as my pool house is 150 feet away from my house. I'm still...

yes, the adjustable flow lets you control from 0.5 to 10 gpd. I figure I can dial in the chlorine without changing my pump/filter duration.

My setup is pretty simple. If you look at the photo. You see the tan timer box, 110v with the outlet to the left of it. I plan on plugging the pump directly to that outlet. Both the Stenner pump and the pump will be on the same timer circuit. I wanted to go with the adjustable pump so I could...

Et all, I've finally given up on my HASA Liqidator. One of the cheap plastic float valves has broken as I was cleaning out the yearly salt buildup. Here's my question. I want to run a variable rate Stenner pump connected to my pump timer that I run approximately 10 hours a day. If I recall what...

About to go onto my 3rd power supply. Purchased new in 2016, 1st supply went in 9/2016 covered under warranty. Power supply #2 started to flake out at the end of last year Sept. Deciding if I should buy another power supply $300, or a different unit. Its $300 vs 1300. I would buy something other...

Thanks for the reply, I'm going to try the 3/8 upgrade and see how well that works. Regards, Cal Settle

I've been running a Liquidator for several years. I clean the tank out each season however the throughput seems to slow each year. It really can't keep up with the. chlorine requirements. The pool is 32,000-gallon gunite/cement. The flow is 70gpm and I run the pump from 6AM to 6PM. I have seen...

I agree, long term I will trench and run new wires from the main panel to the pool house. Note: This is 100-150 ft run. And yes the current setup doesn't meet code. I have been gradually rewiring the entire house, new 200 amp main, new sub etc. My main objective is to reduce the amperage load to...

I have an electrical question. I currently have two 110 runs into my pool house. These are split into two 110 GFI receptacles. One has a Intermatic T101? timer. I'm installing a new pump and would like to go 220v to lessen the amperage running across the two 12/2 feeds. I've ordered the T104...

Does anyone have any experience with the Excel retrofit filter kit for the S7M120? May back can't take changing the monster filter in the STA-Rite any longer.

Yes I have an older gunite pool and the three floor cleaners were converted to be the returns by the previous owner. Three years here and it seems to work well. Sent from my iPad using Tapatalk

Et all; I've pretty well replaced anything non-functioning on my pool this year and I'm just getting to the two skimmers. I have found the replacement weirs online #08650-0022. I have two questions since mine are long gone. 1. Should I go with the original hinge design and if so can someone...

I have a recently purchased home with a cement pool. There are two lights in the pool, neither are working. I have what appears to be two relay boxes next to the outdoor sealed switch which I assume means these are low voltage lights. Before I start my diagnostic routine I though I would pull...