Recent content by busyredhed

I finally ordered my new salt cell and it is on its way. I had a local pool service come out to evaluate my pool for weekly service. He suggested I drain the pool completely and start fresh since calcium is an issue in our area. My husband wants to drain it only half in order to lower the salt...

Thank you!

We had the same problem but my husband tore up the cap and the threads are damaged. Is there a way to replace them? Any ideas? I have uploaded a photo of the damages sleeve. Thank you.

Thank you! It seems poolsupplyworld has the best prices.

Good morning, My turbo cell has been limping along for about 2 years now. It consistently reads lower salt and has to be cleaned every month now for a decent reading. I run diagnostic on it and yesterday it dropped down to 1900 with a real salt reading of 4200. I am now ready to replace it...

That's a great idea! When we took the relief valve apart, it was caked with pieces of debris and grass. Now it works great. Thank you.

Thanks. I will take it apart today and have a look

Hi, Yes, it's 4 cartridge filters. It may be clogged since it was working fine and my filters were filthy from 4 full grown palm trees around the pool that we had clipped this year. We have pressure, the gauge reads and everything is running fine. Can it just have something stuck in the valve?

Hi and help!!!! 1. I just cleaned my salt cell and filters. Everything is properly seated in the filter. 2. My vacuum and overhead water jets are working and vacuum is running the pool fine. 3. My pump almost primes but not quite to the top. 4. I see my skimmer basket from the pool being sucked...

Re: fixed- Hayward aqua logic ps-4 communication error err1 Thank you for the manual and the replies. I turned off the main breakers while I installed a new keypad, bezel and cover on my heater. I hoped that having the breakers off for 2 minutes would reset it. When i turned it on, vualla...

Thank you for the feedback and the manual. I am going to work on these steps. Im hoping its just due to a power outage. We did have one a few weeks back.

My local display panel is giving me the communication error err1 suddenly today. My remotes are working fine and the systems are functioning. Could this be just the cable connecting the display? Or is it always the display itself. I just purchased an american home shield warranty last month...