Recent content by Brian Jones

I have a hayward heatpro hp3100 5t. Just installed. My concern is it doesnt kick off until the rpm on pump goes to about 750. It does kick off if I turn off pump completely. I get e03 code for low flow. My previous unit would shut down anything under 2500 rpm. Does anyone have experience with...

Update: The bubbles I didnt see to tell me it was making chlorine…was because i had the speed too high. Lowered the speed. Noticed the bubbles and you were right. Making chlorine.

I have HEATPRO 110K AHRI HP21104T, Two years old. It turns on, then right off before hitting set temp. No error code. Water flow is fine. Condensation line is not clogged. The problem is this is not consistent. Almost seems it happens when it is very humid. But not sure. Hayward has no service...

Appreciate all the responses. I’ll keep testing.

The cell light goes off and on like it is supposed to. BUT…for two years I have watched this. It always makes little bubbles when that light comes on. Now it doesnt. Chemicals are perfect. Phospates are 1000pb but have always been. It isnt making chlorine. But the lights make you think it is

The cell light goes off and on like it is supposed to. BUT…for two years I have watched this. It always makes little bubbles when that light comes on. Now it doesnt. Chemicals are perfect. Phospates are 1000pb but have always been. It isnt making chlorine. But the lights make you think it is

variable speed Pump 15 gal Have done overnight check It does not make the bubbles like it always has which is why I know its not working. No algae. Pool is crystal clear. But that is because i am using bleach while I figure this out.

Manufacture date is 11/20/2020

FC 3 CYA 50 Ph 7.4 Alk 100

pentair IC 40 2 years Old Lights all on. Looks perfect. However. Not producing Chlorine. All pool chemicals are perfect. No algae in water. It is clear. Cell is clean. I turned off. Reset. Everything. What is wrong?