Recent content by biostockman

I couldn't get it to work in any mode prior to replacing the board. I put it into 'Service' mode and the heater kicked on right away which I'm extremely thankful for. Yes, it is currently connected to the IntelliTouch through the Fireman's 2 wire connection.

So, I got the heater working in Service mode and it's working nicely... Now I need to figure out how to get it working in Auto mode through the ScreenLogic App.

Ok, So I connected locally and had no response at all. Here is my pic:

5 buttons, just like the one on the left. I updated my signature also. Thanks!

Thanks so much for reply! Yes sir, I have it connected through the IntelliTouch system. When I push the heater button on the IntelliTouch panel, it lights up for a second then it goes off. I do not see 888, 128, or 'rX'; I only see r03 for two seconds before it goes dark.

Hello Everyone - The fun began when I opened the pool a few days ago. The heater was completely unresponsive. I tested and confirmed that the unit is getting power so I assumed that the control board was fried... I replaced the board and membrane pad this morning and when I put power to the...

Mine is up and running again

Mine has been down since late Saturday, even the Demo doesn't work so I assume that it's on Pentair's end. There are also posts on Twitter regarding the outage.

My connection has been offline since last night, 'Server Error'. Anyone else having an issue or am I riding solo?