Recent content by bigmoguls

James, Thank you very much. Scott

based on the repair parts, this is the replacement pump component https://www.inyopools.com/Products/07501352026812.htm

So I would PVC weld the union to the PVC coming/going to the plumbing, then use the threaded coupler to the pump intake and output?

It is possible. I live in Houston and we had a big freeze in Feb. My pool is set with freeze protection to run the pumps, we never lost power. But I can't be certain that it never froze.

It is a Starite P6E6E-206L, 1HP. It is 5 years old, what is the typical warranty?

My Starite pump basket housing cracked. I removed the clamp that separates the wet end from the dry end. My challenge is how do I disconnect from the plumbing based on the pictures below? Will I be able to remove the nut from the output connection and then spin the input connection off?

The PB initiated the startup process this afternoon. Sent from my VS986 using Tapatalk

Only 9" of water left until we have a full pool. I won't post a picture until the water gets balanced. Sent from my VS986 using Tapatalk

The red spots are temporary covers for the in-floor pool cleaner nozzles. They put the covers on so the plumbing doesn't get clogged by the Pebbletec.

Blue Smurf applied yesterday. Here are some Pictures. They Pebbletec contractor arrived as I was leaving...Acid wash and starting the fill. I marked my water meter last night so I should get a pretty good measure of the capacity when full. @ummgood. The larger patio and patio...

The blue surf is going on today! Sent from my VS986 using Tapatalk