Recent content by aug0211

Flipped back again and it’s working… for the moment. We’ll see if Pentair will come out and take a look - I suspect the board is bad and it’ll “break” again in a few days. But for now, we’re up and running. NOBODY TOUCH ANYTHING! 😂

Any ideas on why swapping has it back working (on both sensors)?

Thanks! Yes, exactly. Cannot get heat :)

I’m just totally befuddled by this. I swapped the wires at the board again (so air sensor is plugged in to water at board, and Vice-versa). Unplugged main power connector behind board, and had breaker switch for board off. Reconnected main power connected. Flipped breaker on. Panel lit up, I...

EasyTouch. Can’t remember/find how to correct my signature on mobile 🤦‍♂️

Photo of board

Also, any chance anyone can help me track down the right replacement board? Looks very simple to replace myself if I can get the correct board.

The new sensor worked for a few days - just had it out in the open air to make sure it was good before placing in the pipe. Today it failed and I can’t get it back. Swapped air and water sensors at the board connection and sensors seem fine (“air” gets a good reading from whichever sensor I...

Got it, thanks all. I’ll try the replacement recommended and follow up if this doesn’t resolve it. Is it odd to see a sensor go bad reading low opposed to high?

First season pool, Pentair system and water temp sensor has been working fine for a while. Was on vacation and came back and sensor now reads really low. Like 28 degrees. Have calibrated it a bunch of times and it worked for a few hours last night into this morning - now it’s back to low again...

Bummer. Seems odd that SLConfig has an option to hide it - and that it works temporarily, and just doesn’t stick.

Yes it is, but only have a pool.