Recent content by ASchmidt

Remote was set to 100, water temp was 102, heater display said it was set to 102, heater is less than a year old.

We have a Jandy handheld remote and Jandy heater. We are able to turn the heater on from the remote but it’s defaulting to the temp set at the heater and not on the remote. This was confirmed with an independent thermometer tonight in spa mode, I’m assuming the same happens in pool mode. Any...

Out of nowhere our brand new Jandy heat pump won’t run. I know the system is at least partially receiving the call for the heater since the pump speed increases when I turn the heater on with our handheld remote. Since hooking up the remote I never looked at the display but it is on and this is...

I am sure I am missing something simple, but I cannot figure out how to get my pump program to work correctly - I have all Jandy equipment. My filter program and Speed 3 is set 7-3 every day. Speed 3 is supposed to be 2,000 RMPs. I checked this morning and my pump was running at 3,000 RMPs and...

We are in the first month after fill in our Pebble Sheen pool. We have a few rough spots that I’ve discovered, none that seem to be in places that will really bother me. However, will this cause issues down the road with longevity? The circled spot in the spa was the best one I could get a...

We turned on our heater on our new build for the first time today. We set the spa to 102 and it’s gone up to 105 twice now. I have the manual downloaded and will re-read it but anything quick and obvious that I’m missing?

We will be about 26 days post fill next weekend and I’d like to use the heater, I’ve never really seen any plaster dust while brushing so we should be good. Should I/do I need to make any adjustments to the valves? Should any of these have been closed during the plaster start up?

Forgive me, super newbie. Had pool school today, the guy disagreed that the spillover would raise PH. I just let that go and planned to program when he left only to realize I couldn’t. Digging through the forums taught me that Aux3 on the Jandy panel is set up for spillover, I just need to flip...