O
Latest activity Postings Media About
-
-
Oogdento reacted to blairsooley's post in the thread Intellitouch panel no leds lit but Reset button turns them on with
Like.
Yes Tom, you did fix my indoor unit. Much appreciated and thanks for responding again this time. I'd love for you to take a look at what... -
Oogdento replied to the thread Compool valves not working properly.hey you're welcome... i meant to include this link in case you haven't seen it...
-
Oogdento replied to the thread Compool valves not working properly.[EDIT] I should have prefaced this with "run this test to be sure your valves are good" what i usually do to test a valve is connect it...
-
Oogdento replied to the thread Intellitouch panel no leds lit but Reset button turns them on.Hey Blair it sounds like the indoor and outdoor mainboards are toast... I "think" I fixed your indoor for you once before... maybe a few...
-
Oogdento replied to the thread Intellicenter i5P died.
-
-
Oogdento replied to the thread Intellicenter i5P died.Hey @wgipe , I just looked at another dead i5p board and (so far) the bridge rectifier on the 18vac input is shorted (it's the one made...
-
Oogdento replied to the thread Intellicenter i5P died.agh, thanks for asking them about the separate boards... I was nervous the first time I pulled one apart, but if they just told folks...
-
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.yyyikes! i could see from the back side image that the transformer also got hot, but those photos didn't show those scorch marks...
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.Thanks James! that's much easier than flipping between both pages ;) So the burn corresponds to the green resistor hiding behind c4
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.The one I had had traces that had actually melted away... which yours does not have. But comparing the back side image to the top side...
-
Oogdento replied to the thread Intellicenter i5P died.I don't recall @ajw22 's board doing any weird like clicking relays or drawing too much current... so I don't think his relay drivers...
-
Oogdento replied to the thread Intellicenter i5P died.Bummer. Sorry to hear that yours croaked. Do you recall any storm events the day before it died? The faint clicking is...
-
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.hey guys I'm sorry but I don't have any experience with these heater boards (I don't have a heater). I have however seen a Fenwal board...
-
Oogdento reacted to Dan-H's post in the thread replacing easytouch 8 circuit board; a couple of questions with Like.
Thanks @ogdento I stumbled across the actuator fix a couple of years ago. I had four pentair actuators fail and thankfully had not...
-
-
Loading…
-
Loading…
-
Loading…
