1
Latest activity Postings Media About
-
-
1Do not use the light. Replace the light.
-
11poolman1 replied to the thread Polaris 280 refuses to go into one part of shallow end.It looks like there is a return line right above that area. It may be forcing the hose away from that area. It looks like there is a...
-
11poolman1 replied to the thread Circupool Core55 or RJ60?.If you get the RJ60 and want to mount it vertically, be sure that it is in a pipe that has upward waterflow to be sure the plates are...
-
11poolman1 replied to the thread Jandy AquaPure EI APURE35 SWG breather tube.Angle at the top. Why? I don't know, that's how the manufacturer does it. Probably helps evacuate the air. faster. It is there to make...
-
11poolman1 reacted to ajw22's post in the thread Pentair Mastertemp 400 Stack Flue Sensor Immediate Shut down with
Like.
If the heater throws an SFS error before the blower runs and the heater starts, the Stack Flue Sensor is bad. Stack Flue Sensors on... -
1Each market bears what it will bear for installation. Call several companies and get quotes. You may find many companies won’t install...
-
11poolman1 replied to the thread Solar Heater 270,000 BTU.Average heat increase with a properly sized (80% coverage) system is 5-7 degrees per day. Average heat loss is 3-5 degrees at night...
-
11poolman1 replied to the thread New Pool Filter for a 38,000 Gallons pool.Preference and budget. Internally, virtually all filters of a type are the same. In the case of DE. they all use the same grids unless...
-
11poolman1 replied to the thread New Pool Filter for a 38,000 Gallons pool.New filter time.
-
11poolman1 replied to the thread New Pool Filter for a 38,000 Gallons pool.Where is it leaking? A crack? At the O ring? Most leaks can be stopped safely. A crack can't be.
-
11poolman1 replied to the thread Pool heater.A larger heater heats the water faster. Because the heat exchanger is larger, it heats more water at a pass through it than a smaller...
-
11poolman1 replied to the thread Hayward SP3400VSP with OMNI controller on top.Yes, the shaft seal leaked. That's what damaged the front bearing. You will still need a GO KIT 80V. That has the shaft seal and O rings...
-
11poolman1 reacted to JamesW's post in the thread Leak from light conduit. (Junction box is 12” higher) with Like.
The rule still applies. The junction box is too low. Run conduit from the mounting location up to the junction box such that the...
-
11poolman1 replied to the thread Hayward SP3400VSP with OMNI controller on top.Your pump failed because the seal leaked/wore out and damaged the bearings. It happens to all pumps eventually. My EcoStar is 15 years...
-
11poolman1 replied to the thread New Pool Filter for a 38,000 Gallons pool.Since the backwash valve would be removed with a cartridge filter you could move the filter tank away from the house (its touching the...
-
-
Loading…
-
Loading…
-
Loading…