Latest activity Postings Media Albums About
-
-
Jimrahbe replied to the thread Help with spillover losing water (needed for hot tub water filtration).L, You need a channel cut under the spillover that is about 1/4" back from the lip, about 1/4" wide and about 1/4" deep.. This will... -
Jimrahbe reacted to 1poolman1's post in the thread Spa jets stop working for overflow into pool with
Like.
You didn't mention solar initially. That makes a huge difference. It would be amazing if 1100 RPM properly filled the solar array... -
Jimrahbe reacted to crystallake's post in the thread Spa jets stop working for overflow into pool with Like.
Hello again, Thought I'd update on my findings. I cleaned my filter and that didn't solve the issue, but after some more...
-
Jimrahbe replied to the thread Pool Feature Oddities When Using ScreenLogic.Y2, The only oddity is you.. :mrgreen: When you turn on the cleaner, there is a delay to make sure the main pump is running first...
-
When you chemically cleaned the cartridge, was it an acid cleaning? If so it is very likely the cartridge is destroyed. Using acid...
-
Jimrahbe replied to the thread Salt Cell On It’s Last Legs?.rev, Almost ever time I think my cell is not producing enough FC, it has been because my CYA has drifted a little too low.. For me...
-
Jimrahbe replied to the thread Short in IC40 power cord plug.Danny, Try this .. Amazon.com Thanks, Jim R.
-
You probably need new filter cartridges at this point. Adding any form of clarifier or floc to a cartridge filter system is a recipe...
-
Jimrahbe replied to the thread Flow Issue (Help!).Well... Where to you think the clarifier went??? :mrgreen: Let's think about... You can run without the cartridge and you get...
-
Jimrahbe replied to the thread Spa phone app issues.T, Just to be clear, in most pools the the Spillover and the Pool/Spa modes are two different things. When you use your automation...
-
Jimrahbe replied to the thread Flow Issue (Help!).Cody, Cartridges should last for many years.. I changed mine at 8 years and it hardly made any difference at all.. In your case, I...
-
Jimrahbe replied to the thread Spa phone app issues.T, What automation system do you have??? When you use the automation itself, does the system switch between the Pool mode and Spa mode...
-
Jimrahbe reacted to PoolStored's post in the thread Trying to figure out the right SWG for my pool -seeking suggetions with Like.
Not likely. I do the same and use liquid chlorine until the pool gets to about 55, then SWCG kicks on. Every cell is different, check...
-
Jimrahbe replied to the thread Clogged main drain?.G, I suspect that the pipe before the IFCS dome is for return water from the spa when the cleaner is on.. But I really know nothing...
-
Jimrahbe reacted to Dirk's post in the thread IC40 says salt level is low while salt level reads 3800ppm. New flow switch added. with Like.
Ha, I just read that back and it sounded a bit like a payola scheme. To be clear, the money you donate to TFP goes to infrastructure...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…