Latest activity Postings Media Albums About
-
-
mknauss replied to the thread Salt Cell On It’s Last Legs?.What is the Instant Salt reading from the SWCG versus an actual salinity using a K1766 test kit? -
mknauss replied to the thread PoolMath Update frustration lol.You can edit individually. I have been using beta version of this for months. I have had no issues.
-
mknauss replied to the thread PoolMath Update frustration lol.Please send this information to [email protected]
-
mknauss replied to the thread Featured Low CL.So every time you add water due to evaporation, your CH will rise. Up to you if you want to spend money adding calcium.
-
mknauss replied to the thread Featured Low CL.No. What is the CH of your fill water?
-
mknauss replied to the thread High PH, low TA, and low CYA on opening -- order to add chemicals.It is chemically not possible to have a pH of 8.7 and a TA of 47. The pH/TA balance would max out the pH at about 8.3.
-
mknauss replied to the thread Featured Low CL.My pool has been installed for a little more than 8 years. My CH is always high because of high CH fill water. I use softened water for...
-
mknauss replied to the thread Featured Low CL.In your situation, no need to add calcium. I suspect your fill water has calcium in it. The CH will rise as you add fill water to the...
-
mknauss replied to the thread Fiberglass Pool Chemistry.I suspect that is coming from the SWCG. Your very high TA will cause the cell to create a lot of scale.
-
mknauss replied to the thread Pentair Mastertemp 400 controls.Your automation is the ET. The heater is a dumb device. By using the firemans switch, you simply are turning the heater on and off via...
-
mknauss replied to the thread Pentair Mastertemp 400 controls.When you connect the ET to a heater using the firemans switch, the thermostat on the Heater should be set to its max. Typically that is...
-
mknauss replied to the thread How long to aerate pool to raise pH.You are adding lots of make up water due to evaporation right now. That water is high in TA. Even without the curing plaster, pH rise is...
-
mknauss replied to the thread Green Algae.Sorry, but that is not crystal clear.
-
mknauss replied to the thread Featured Multiple SLAM attempts.Limit the main drain to no more than 10% open.
-
mknauss replied to the thread Featured Multiple SLAM attempts.Filters filter better at low flow rates. At the high rpm with that pump you are blowing material through that sand filter.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…