Latest activity Postings Media Albums About
-
-
mknauss replied to the thread Hello from Oklahoma.Welcome to the forum! I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV -... -
mknauss replied to the thread Pool/Spa return tied together?.That is the spa make up line. It will always, by design, add water to the spa when the system is in Pool mode. When in Spa mode, the...
-
mknauss replied to the thread Calcium Chloride Brand.Is that your fill water? I would be careful raising the CH too much. Best to maintain a bit higher TA and pH and keep the CH lower such...
-
mknauss replied to the thread Calcium Chloride Brand.I am curious. Fill water in Glendora I would suspect is primarily from the Colorado River. Thus your fill water CH is 250 ppm. So I...
-
mknauss replied to the thread Post partial drain chemical help.It would have been best to do a complete drain and refill. If you are not using softened water for make up water, you will need to do a...
-
mknauss replied to the thread Pool with SWG and sulfuric acid question.If you regularly exchange large amounts of pool water with fresh water, then it can work. Such as if you have a sand filter that is back...
-
mknauss replied to the thread Pool with SWG and sulfuric acid question.https://www.troublefreepool.com/wiki/index.php?title=Acid#Sulfuric_Acid
-
mknauss replied to the thread easytouch need a 5th valve controller.You cannot add a 5th actuated valve to an Easytouch directly. You would need to use a relay. Your suction cleaner (not a robot) likely...
-
mknauss replied to the thread Help me set my pump speed.So you need to find the rpm the heater functions at and make that your Pool Heater Active Circuit.
-
mknauss replied to the thread Help me set my pump speed.Do not mix RPM and GPM. I suggest you set everything up using RPM. You show a Heater Active function, but no heater in your signature...
-
mknauss replied to the thread Help me set my pump speed.OK. So your Pool Mode should be the base RPM you need to run for the SWCG to operate. Set that Mode for the entire time you wish to run...
-
mknauss replied to the thread Help me set my pump speed.So you likely have automation. Easytouch with Screenlogic?
-
mknauss replied to the thread Black algae & old PebbleTec finish. Remodel and refinish, or savable?.From the article. Copper stain treatment does not remove the copper from your water, it only removes the solid copper stain from the...
-
Loading…
-
Loading…
-
Loading…
-
Loading…