Recent content by 6010fd12

I live near up north so I think insulation is a must for me. Just trying to figure out a solution that isn't "permanent" in case I have to repair something in the future. It was a NIGHTMARE digging out the hard foam surrounding the nuts on the jet body. Don't want to have to do that again if I...

Just replaced all the jets on my 2013 jetsetter and now I want to replace the insulation that I had to rip off. I still have the old foam but most of it is in smaller pieces so it would be a little difficult to reuse. I want to avoid using spray on foam (except for the bottom of the tub that I...

Gotcha. Thank you. Gonna try the loctite one and see if that helps. Also could I get your thoughts on which liquid leak seal you would reccomend that I use to circulate in the spa just in case I missed any other invisible or pinhole leaks? There is no other visible leaking but I just want to...

In your opinion which do you think works better? Loctite or JBWeld? Also is there any prep I need to preform on the outside surface before applying it? Sanding, cleaning, etc.? As for the front should I try to push/hammer in the crack so that it's flush with the shell before applying the epoxy...

Are you sure the water weld won't erode away with all the harsh chemicals? Also here is a better picture of the damage.

I looked up pool putty but a lot of the reviews mentioned that it was only a temp fix as the chemicals in the spa would wash it away over the years. Maybe Plastaid?

I have a 2013 Jetsetter and while dremeling out one of the old jets, the cutoff disk must have slightly touched the shell and now there is a very small less than a 1/4 inch crack in the shell by the jet. What is the best method to patch this up? Here is a video of the leak.